Інформація про відкликання статті "Тертя та зношення кристалів полістиролу при ковзання по сталі 100Cr6 у незмащеному контакті" (ФХТТ: (2022), 23(2), (293-301), https://doi.org/10.15330/pcss.23.2.293-301)
DOI:
https://doi.org/10.15330/pcss.23.2.293-301Ключові слова:
сухе зношення, трибологія, кристал полістиролу, пластична деформація, стиранняАнотація
The Editor-in-Chief has retracted this article.
This paper was submitted to the journal Physics and Chemistry of Solid State on October 13, 2021. On November 17, 2021, the article was checked by the Unicheck system and was recommended for work with reviewers. But, the identical paper under the same title "Friction and wear of polystyrene crystal sliding against steel 100Cr6 in unlubricated contact" by the same authors was accepted in journal Tribology in Industry (http://www.tribology.rs) on September 29, 2021, and the signed Copyright Agreement.
However, the authors did not report that they had previously signed a Copyright Agreement with the journal Tribology in Industry.
One of the conditions of submission of a paper for publication is that authors declare explicitly that their work is original and has not appeared in a publication elsewhere. Re-use of any data should be appropriately cited. As such this article represents a severe abuse of the scientific publishing system. The scientific community takes a very strong view on this matter and apologies are offered to readers of the journal that this was not detected during the submission process.
Посилання
V.G. de Bie, P.D. Anderson, L.C.A. van Breemen, The effect of an adhesive interaction on predicting the scratch response of PS/PPO blends, Polymer vol. 172, 91 (2019); https://doi.org/10.1016/j.polymer.2019.03.057.
G.M. Bartenev, V.V. Lavrentev, Friction and wear of polymers (Amsterdam: Elsevier, 1981).
S. Sharma, J. Bijwe, S. Panier, Exploration of potential of Zylon and Aramid fibres to enhance the abrasive wear performance of polymers, Wear 422–423, 180 (2019); https://doi.org/10.1016/j.wear.2019.01.068.
H.J. Mathieu, E. Bergmann and R. Gras, Surface analysis and technology (TM volume 4): thin films and tribology, Polytechnic and university presses Romandes, CH - 1015 (Lausanne, Switzerland, 2003). (in French).
P. Decroly, N. Heyymans, H. H. Kauch and C. J. Plummer, Polymeric materials: Mechanical and physical properties, Polytechnic presses and University of Romandes, CH - 1015 (Lausanne, Switzerland, 2001). (in French).
A. Pogačnik, A. Kupec, M. Kalin, Tribological properties of polyamide (PA6) in self-mated contacts and against steel as a stationary and moving body, Wear 378-379, 17 (2017); https://doi.org/10.1016/j.wear.2017.01.118.
B. Chen, J. Wang, F. Yan, Friction and wear behaviors of several polymers sliding against GCr15 and 316 Steel under the lubrication of sea water, Tribol Lett 42(1), 17 (2011); https://doi.org/10.1007/s11249-010-9743-9.
J.W.M. Mens, A.W.J. de Gee, Friction and wear behavior of 18 polymers in contact with steel in environment of air and water, Wear 149(1-2), 255 (1991); https://doi.org/10.1016/0043-1648(91)90378-8.
J. Fisher, D. Dowson, H. Hamdzah and H.L. Lee, The effect of sliding velocity on the friction and wear of UHMWPE for use in total artificial joints, Wear 175(1-2), 219 (1994); https://doi.org/10.1016/0043-1648(94)90185-6.
M. Yahiaoui, F. Chabert, J.-Y. Paris, V. Nassiet, J. Denape, Friction, acoustic emission, and wear mechanisms of a PEKK polymer, Tribology International 132, 154 (2019); https://doi.org/10.1016/j.triboint.2018.12.020.
M.L. Cannaday and A.A. Polycarpou, Tribology of unfilled and filled polymeric in refrigerant environment for compressor applications, Tribology letters 19(4), 249 (2005); https://doi.org/10.1007/s11249-005-7441-9.
D. Nilsson, B. Prakash, Static/dynamic friction and wear of some selected polymeric materials for conformal tribo-pairs under boundary lubrication conditions, Friction 1(3), 232 (2013); https://doi.org/10.1007/s40544-013-0020-4.
B.B. Jia, T.S. Li, X.J. Liu, P.H. Cong, Tribological behavior of several polymer-polymer sliding conditions under dry friction and oil-lubricated conditions, Wear 262(11-12), 135 (2007); https://doi.org/org/10.1016/j.wear.2007.01.011.
D.W. Gebretsadik, J. Hardell, B. Prakash, Friction and wear characteristics of PA 66 polymer composite/316L stainless steel tribopair in aqueous solution with different salt levels, Tribology International 141, 1 (2020); https://doi.org/10.1016/j.triboint.2019.105917.
E. Santner, H. Czichos, Tribology of polymers, Tribology International 22(2), 103 (1989); https://doi.org/org/10.1016/0301-679X(89)90170-9.
O. Olea-Mejia, W. Brostow, E. Buchman, Wear resistance and wear mechanisms in polymer+metal composites, Journal of Nano science and Nanotechnology 10(12), 1 (2010); https://doi.org/10.1166/jnn.2010.3026.
H. Xu, Z. Feng, J. Chen, H. Zhou, Tribological behavior of the carbon fiber reinforced polyphenylene sulfide (PPS) composite coating under dry sliding and water lubrication, Materials Science and Engineering A 416(1-2), 66 (2006); https://doi.org/10.1016/j.msea.2005.09.094.
W. Brostow, V. Kovacevic, D. Vrasljko and J. Whitworth, Tribology of polymers and polymer-based composites, Journal of Material Education 32(5-6), 273 (2010).
B. Bhushan, Principles and applications of tribology, 2nd ed. (IEEE Press, New York 1125, 1996).
B.T. Ho, T.K. Robert, S. Lucas, An overview on biodegradation of polystyrene and modified polystyrene: the microbial approach, Critical Reviews in Biotechnology 38(2), 308 (2018); https://doi.org/10.1080/07388551.2017.1355293.
R. Gilardi, Tribology of Graphite-Filled Polystyrene, Lubricants 4(2), 1 (2016); https://doi.org/10.3390/lubricants4020020.
Z. Yang, B. Dong, Y. Huang, L. Liu , F.Y. Yan , H.L. Li, Enhanced wear resistance and micro-hardness of polystyrene nanocomposites by carbon nanotubes, Materials Chemistry and Physics 94(1), 109 (2005); https://doi.org/org10.1016/j.matchemphys.2005.04.029.
C. Lynwood, Polystyrene synthesis, characteristics and applications (Ed. Nova Science Publishers, New York, 2014).
Y. Yamaguchi, Tribology of plastic materials: their characteristics and applications to sliding components (Amsterdam, Elsevier, 1990).
D.M. Nuruzzaman, M.A. Chowdhury, Friction and wear of polymer and composites, Chapter 14, Composites and their properties (book edited by Niag Hu, Rijeka, Croatia, 2012).
H. Unal and A. Mimaroglu, Friction and wear behaviour of unfilled engineering thermoplastics, Materials & Design 24(3), 183 (2003), https://doi.org/10.1016/S0261-3069(03)00018-9.
D.H. Cho, B. Bhushan, J. Dyess, Mechanisms of static and kinetic of polypropylene, polyethylene terephthalate, and high-density polyethylene pairs during sliding, Tribology International 94, 165 (2016); https://doi.org/org/10.1016/j.triboint.2015.08.027.
N.K. Myshkin, M.I. Petrokovets, A.V. Kovalev, Tribology of polymers: Adhesion, Friction, and mass-transfer, Tribology International 38(11-12), 910 (2005); https://doi.org/10.1016/j.triboint.2005.07.016.
N.K. Mayshkin, S.S. Pesetskii, A.Ya. Grigoriev, Polymer tribology: current state and application, Tribology in industry 37(3), 284 (2015).
E. Santner, H. Czichos, Tribology of polymers, Tribology International 22(2), 103 (1989), https://doi.org/10.1016/0301-679X(89)90170-9.
S.K. Sinha, Handbook of Polymer Tribology (Edited By Indian Institute of Technology Delhi, India, 2018).
L.W. McKeen, Fatigue and tribological properties of plastics (Third edition Elsevier Cambridge, USA, 2016).
N. Khanafi-Benghalema, E. Felderb, K. Loucif, P. Montmitonnet, Plastic deformation of 25CrMo4 steel during wear: Effect of the temperature, the normal force, the sliding velocity and the structural state, Wear 268(1-2), 23 (2010); https://doi.org/10.1016/j.wear.2009.06.036.
K.A. Laux, A. Jean-Fulcrand, H.J. Sue, T. Bremner, JSS. Wong, The influence of surface properties on sliding contact temperature and friction for polyetheretherketone (PEEK), Polymer 103, 397 (2016); https://doi.org/10.1016/j.polymer.2016.09.064.
S. Bistac, A, Ghorbal, M. Schmitt, Friction of polystyrene: Consequence on nano-wear, Progress in Organic Coatings 55(4), 345 (2006); https://doi.org/10.1016/j.porgcoat.2005.12.005.
S Bistac, M. Schmitt, A. Ghorbal, E. Gnecco, E. Meyer, Nano-scale friction of polystyrene in air and in vacuum, Polymer 49(17); 3780 (2008); https://doi.org/10.1016/j.polymer.2008.06.032.
S.F.S.P. Looijmans, V.G. de Bie, P.D. Anderson, L.C.A. van Breemen, Hydrostatic stress as indicator for wear initiation in polymer tribology, Wear 426(2), 1026 (2019), https://doi.org/10.1016/j.wear.2018.12.019.
R.H. Rice, E. Gnecco, R. Wannemacher, R. Szoszkiewicz, Velocity dependence of nano-abrasive wear of amorphous polymers obtained using a spiral scan pattern, Polymer 54(14), 3620 (2013); https://doi.org/10.1016/j.polymer.2013.05.015.
D.D. Woodlaand, W.N. Unertl, Initial wear in nanometer-scale contacts on polystyrene, Wear 203, 685 (1997); https://doi.org/10.1016/S0043-1648(96)07415-7.
K.L. Johnson, Contact mechanics (Cambridge University Press, Cambridge, 1996).
K. Shooter and RH. Thomas, Frictional properties of some plastics, Research 2, 533 (1952).
J.F Archard, Elastic Deformation and the Laws of Frictions, Proc. R. Soc. Lond. A 243, 190 (1957); https://doi.org/10.1098/rspa.1957.0214.
T.F. Andrade, H. Wiebeck, A. Sinatora, Effect of surface finishing on friction and wear of Poly Ether-Ether-Ketone (PEEK) under oil lubrication, Polímeros, 26(4), 336 (2016); https://doi.org/0.1590/0104-1428.2183.
M.D. Bermudez, F.J.C. Vilches, G.M. Nicolás, Wear of Liquid Crystal-Additivated Polymers Against Steel, Journal of Applied Polymer Science 74(4), 831 (1999); https://doi.org/10.1002/(SICI)1097 4628(19991024)74:4<831::AID-APP9>3.0.CO;2-E.
H. Unal, U. Sen, A. Mimaroglu, Dry sliding wear characteristics ofsome industrial polymers against steel counterface, Tribology International 37(9), 727 (2004); https://doi.org/10.1016/j.triboint.2004.03.002.
T.A. Blanchet, F.E. Kennedy, Sliding wear mechanism of polytetrafluoroethylene (PTFE) and PTFE composites, Wear 153(1), 229 (1992); https://doi.org/10.1016/0043-1648(92)90271-9.
Опубліковано
Як цитувати
Номер
Розділ
